|
Half hitch useful as temporary attaching knot, the half-hitch begins many other knots. It will hold against a steady pull on the standing part, especially with a stopper such as figure-8 or stevedore's knot (in the end). A favorite is a round-turn with 2 half-hitches. |
|
Slippery half-hitch By now you should be able to imagine how to do this. An overhand knot with a bight at the end to run thru the eye of the knot. |
![]() |
Two half-hitches Very reliable for attaching a rope to a pole or mooring. To finish, push the 2 half-hitches together and snug them by pulling on the standing part. |
Round turn and 2 half-hitches Wind the rope around the post 1.5 times (360+180 degrees) then do 2 half-hitches. This provides friction to absorb the jerking of the standing part.
| |
![]() |
Timber hitch For strain parallel to log. Important for dragging a heavy object like a log, it will hold firmly so long as there is a steady pull. Slackening or jerking may loosen it. Use a killich (anchor) hitch for dragging, by adding a hitch to the front of the log or similar, to guide it.
Stuns'l hitch
For strain perpendicular to log.
|
|
Clove hitch Widely used, by running around the post 2x in only one direction, it puts little strain on the rope, and bites into the post instead of cutting back against the rope. If the top of the post is within reach, you can drop 2 underhand loops over it, and draw them tight.
|
![]() |
Clove hitch over bar Threading the end under the standing part, is necessary when the end of the post is not accessible.
|
|
Slipknot
Unless a strain is kept on it, it may slide; thus inferior to the 2-half-hitches. Fig B shows it as an overhand knot around the standing part. Fig A1 holds better by using the standing part first then the loop is placed over the object. Tie a stopper for security, before beginning.
| |
|
Pipe hitch Useful for lifting a bar or post straight up, such as when pulling it from the ground. Take 4 or 5 turns around the post; cross the end over then 2 half-hitches. An added hitch is usually taken further up to keep the post vertical.
|
|
Masthead knot Now only for decorative purposes but was used as a strap around a temporary masthead to which straps could be fastened.Begins with 3 overlapping hitches. The inner bights of the 2 outer hitches are led in regualr sequence over and under to the opposite sides of the knot, while the upper bight of the center hitch is extended.
|
|
Rolling or taut-line hitch These 2 hitches are the same knot used in different ways Fig A, B, C show the rolling hitch around a pole. In a rescue this could be tied in a taut rope, using only one hand to wrap the rope around your body.
Fig D shows the taut-line hitch to tighten tent ropes. |
![]() |
Stopper hitch Same as taut-line hitch except that turns 1 and 2 are reversed. Neither hitches will slip down even on smooth surfaces.
|
|
Hitching tie Common for hitching animals.The second move forms a slippery hitch until the end is brought down thru the eye, locking it.
|
![]() | Anchor bend Also called fisher's bend,is one of the strongest hitches. Two turns around the post or ring, then bring the end over the standing part and thru the loop. Finish with 2 half-hitches.
|
|
Single blackwall Half-hitch over a hook; looped from around the back of the hook. Will hold only under constant strain. A stopper will help. Untrustworthy.
|
|
Double blackwall Looped from around the front of the hook. A little safer than the single, but not much. Bowline is better.
|
| Cat's-paw Better than either blackwalls; will not slip not need constant strain. Two loops turned inwards one or two complete turns; hang eyes over hook.
|
| Thames hitch Or tugboat hitch,; a mooring hitch to a post; 2 turns around post with a single line; make a bight and pass under standing part, then back over post. Pull tight. |