_____________
|
Square or reef knot Put 2 ropes together, left over right, then go back but putting right over left. Never do two left-over-rights because this, a granny knot, often slips or becomes difficult to undo. To loosen, push the ends towards the knot or pulling one end toward the other end.
|
_____________
|
Shoestring knot A square knot with slippery ends. Left-over-right then right-over-left, but the second time use loops. This is done by forming loop A first then passing the standing part of B around it, and thru its own bight. Do not let B's end come thru the bight. Now tighten.
|
|
Surgeon's knot A square knot with an extra twist in the first left-over-right. Used by surgeon's to hold the twine tight while adding the right-over-left.
Useful for tying parcels. Do the first left-over-right with an extra twist, pull tight, then jerk the ends in a swivel action to pull in opposite directions. This makes the loops grip to prevent slipping. Then do the second overhand to complete the knot. Pull tight. |
_____________
|
Sheet bend The most important knot for joining 2 rope ends, particularly if the ropes have different diameters. Bend = to tie; sheet = ropes attached to the lower ends of the sails to pull them taut.(Halyards are attached to the top of the sails to pull them up the mast.)
Begin with the bight in the left rope. Pass the right rope up thru the bight and around the back of both parts of the bight. Then thread the end of the right rope under itself, that is, between the bight of the left rope and itself. This is also called the weaver's knot, done with different hand actions to give the same knot. Place the larger rope in the left hand. |
| Slippery sheet bend An ordinary sheet bend with a bight added to ease its release. Just tug on the end of the bight. Handy to quick release or when frequently tying and untying.
|
| Fisher's knot Used for joining 2 fine lines such as fishing leaders. Two overhand knots, one on each line, around the other line.Pull each knot taut separately until snug, then pull the standing parts till the knots catch up against each other.
|
_____________
|
Single Carrick bend These 2 Carrick bends are used on large hawsers for towing ships. They are among the strongest knots but need to have ends seized to their standing parts. (You would not want to untie them often.) Begin with a bight in the left rope then weave the right rope thru as shown.
|
_____________
|
Double Carrick bend Like the Single Carrick but instead of a bight, begin with an underhand loop. This gives 2 crossovers instead of one.
|