Lashing
Back to net & rope index
Lashing
For lashing or binding together timbers with rope.
It is important to use ropes of correct thickness and length:
As to length, figure 1m per 25mm of the combined diameter of the spars. Ex: when lashing 75mm and 100mm timbers together, you need 75/25 + 100/25 = 3m + 4m = 7m of rope.
DiagonalLashing 1 not found DiagonalLashing 2 not found
 
 
Diagonal lashing
Used to spring 2 spars together, that is, to join 2 spars which do not touch wher they cross:
  • Use a timber hitch where they cross. Tighten it to draw the the two close.
  • Take 3 or 4 turns around one fork; 3 or 4 around the other.The turns should be beside each other, not on top of each other.
  • Take 2 frapping turns about the lashing at the point where the spars cross, as in the lower drawing.
  • Finish with a clove hitch around either spar.
Back to Contents
SquareLashing not found
Square lashing
Used whenever spars cross at an angle, touching each other:
  • Place a clove hitch aaround the upright, directly below where the crosspiece will be. Tighten it.
  • Twist the free rope end and the standing part around each other to hold the loose end.
  • Wrap the rope behind the upright, down in front of the crosspiece, and around behind the upright. Do 4 times, keepingoutside the previous turns on the crosspiece and inside them on the upright..
  • Make 2 or 3 frapping turns between the timbers and strain tightly.
  • Finish with a clove hitch on the crosspiece.
  • Make all turns as tight and secure as possible.
Back to Contents
ShearLashing not found
Shear lashing
Used for forming shear legs of timbers with their butt ends spread apart, as in pioneering bridges:
  • Lay the spars parallel to one another.
  • Tie a clove hitch around one spar.
  • Bind 2 timbers by laying 7 or 8 turns around them, loosely, one turn beside the other.
  • Make 2 frapping turns around the lashing between the spars.
  • Fasten the rope end with a clove hitch around the 2nd timber.
  • Open out the 2 timbers to form the shear legs.
  • If the 2 spars are lashed merely to extend one of them (as in a flagpole) do not use frapping turns.
Back to Contents
TripodLashing not found
Tripod lashing
The middle leg is extended to the opposite direction to that of the outer legs:
  • Lay 3 spars on the ground, pointing in alternate directions.
  • Make a clove hitch or timber hitch around one of the outside spars.
  • Take 7 or 8 loose lashing turns around all 3 spars.
  • 2 frapping turns in the spaces between.
  • Finish with a clove hitch on the center spar.
  • Hoist the tripod into place.
Back to Contents

Back to net & rope index